静止轨道星载差分吸收光谱仪CCD成像系统设计

静止轨道卫星差分吸收光谱仪采用摆扫成像方式对大气进行探测,针对其工作时CCD成像系统信噪比大于1 000、高速探测模式下探测周期小于10min、高分辨率模式下探测周期小于1h的要求,进行CCD成像系统设计.选取CCD47-20作为探测器,设计成像电路实现光谱图像信号的采集和上传.分析了帧叠加和像元合并对时间、空间分辨率的影响.结合帧转移CCD的特点设计了每个位置最后一帧读出时摆镜转动的成像方式,并合理设置了帧叠加数和像元合并数,达到优化成像周期的目的.1s曝光时间条件下,该CCD成像系统的高速、高分辨率模式探测周期分别为515s和3 315s,图像信噪比均大于1 000,污染物观测实验中未出现失帧或重复的现象.该CCD成像系统方案满足静止轨道星载差分吸收光谱仪的探测需求,为静止轨道环境监测仪器设计提供参考.     

银纳米微粒荧光猝灭法测定水中痕量ClO2

在pH 9.1的NH4Cl-NH3·H2O缓冲溶液中,银纳米微粒在470 nm处产生一个荧光峰;它能被ClO2氧化导致体系的荧光发生猝灭.ClO2浓度在0.001 1～0.185μg·mL-1范围内与荧光猝灭强度成良好的线性关系,检测限为0.004 7μg·mL-1 ClO2.据此建立了测定ClO2的荧光分析新方法,用于饮用水中ClO2的测定,结果满意.     

仓库容量有限条件下的随机存贮管理问题的评注

给出2005年全国部分高校研究生数学建模竞赛D题的研究背景,对参赛论文作了简要评注,并提供了一种参考解答.     

高温超导体Josephson阵列在磁场中的微波响应与磁通涡旋激发

本文从分析相变电阻率 ρP 和磁通蠕动电阻率 ρF 出发 ,指出当T小于某一温度T0 时 ,ρF>ρP,而当T >T0 时 ,ρF 远小于 ρP,并进一步分析了 ρF 与 ρP 随温度的变化率分布图 ,得出磁通蠕动电阻率 ρF 随温度的变化率分布图跟微波响应曲线具有相似的分布特征 ,结果表明 :高温超导体的非平衡微波响应机制可能与磁通涡旋的激发有关 .     

三维流动传热空隙率计算程序FASTOR—3D开发研究

1引言大粘度（大r）和大系数（ss和sc）法是处理流动区域中障碍物的常用方法山。但当流动区域中障碍物数量较多时，宜采用空隙率来模拟障碍物，如模拟反应堆流动传热的商用程序COMMIX［’］。我们根据空隙率模拟的基本概念，针对采用交错网格的压力校正法，自行编制了多障碍物流动传热三维计算的全部源程序代码，应用于某核反应堆钠池流动传热的数值模拟，获得了比较合理的结果。2数学模型和数值方法2．1控制方程空隙率修整的质量、动量、能量及湍流动能与耗散率的守恒方程通式的三维柱坐标形式为其中中一1，。，。，。，T，k，。分别表…     

Outline Imaging by THz Time Domain Spectroscopy

Outline imaging by THz time domain spectroscopy is proposed. Spectroscopic splitting at interface is reported, The principle of outline imaging is put forward. Experimental results demonstrate the feasibility of outline imaging by spectroscopic splitting, It is shown that clear out：line image of sample interface could be achieved easily by this technique. The spatial resolution is about 0.6mm. The THz-beam focus, the scanning step and the THz pulse width are the critical foctors affecting the imaging resolution. The signal-to-noise ratio of this technique could be improved greatly compared to the conventional transsion imaging.     

GeⅩⅪ-SeⅩⅩⅢ离子n=3,Δn=0跃迁谱线和振子强度的计算

用HFR方法对CaⅨ-KrⅩⅩⅤ离子3s2,3s3p,3s3d,3p2组态能级结构进行了理论计算.在已有实验研究的基础上,通过分析离子能级沿等电子序列的变化规律,运用最小二乘拟合方法预言计算了GeⅩⅪ-SeⅩⅩⅢ离子3s2,3s3p,3s3d,3p2组态14条精细结构能级值.在此基础上,进一步计算了GeⅩⅪ-SeⅩⅩⅢ离子3s2-3s3p,3s3p-3s3d和3s3p-3p2跃迁的23条谱线波长和相应的振子强度.计算结果与已有的实验值十分吻合,波长的最大不确定度为0.008 nm.     

聚异丁烯高活性端基含量及相对分子质量测定方法的研究

综合使用核磁，VPO和近红外光谱分析技术对聚异丁烯活性端基含量以及相对分子质量的测定进行了详细研究，分别建立核测定聚异丁烯活性端基含量以及其他烯键含量和近红外光谱快速测量聚异聚丁烯活性端基含量。其他烯键含量和相对分子质量的分析方法。成对t检验结果表明，近红外光谱分析方法测定结果与核磁和VPO方法测定结果之间无显著性差异。     

掺Perylene的PVK薄膜荧光谱及发光机理

用高荧光效率的有机染料芘(perylene)掺杂聚乙烯咔唑(PVK),其荧光光谱与芘的发射光谱基本一致,而且亮度比纯芘发光提高十多倍,说明发光主要来自芘分子,并在PVK和perylene之间存在十分有效的能量传递或电荷转移过程,荧光谱强度随掺杂浓度的变化关系说明存在一个最佳的掺杂浓度比.分析PVK和perylene之间可能发生的能量转移过程,认为从PVK到perylene这种能量转移与实验不符;分析PVK和perylene薄膜的光致发光过程,认为从(PVK+)→(perylene+)和从(PVK-)→(p     

PINNING EFFECT OF LEAD LANTHANUM TITANATE THIN FILMS DEPOSITED ON DIFFERENT SUBSTRATES

Pinning effect of lead lanthanum titanate (PLT) ferroelectric thin films with excess PbO of 20 mol% has been studied for deposition on diffe rent substrates. Silicon, sapphire and quartz were used as substrates on which P t/Ti or LaNiO₃ thin films were deposited as bottom electrodes. Electron probe analysis results showed that there was still a certain amount of excess Pb in PLT films after annealing at 550 ℃ for 1 h, and the amount of it was dependent on the substrate used. The distribution of excess Pb in the films was investig ated by Auger electron spectroscopy depth profile. It was shown that the substrates and the bottom electrodes had significant effects on the content and distrib ution of excess Pb in PLT films. The excess Pb and its accumulation at the inter face between the film and bottom electrode may act as pinning centers and have a pinning effect on domains, which can be observed by abnormal P-E hysteresis loops and abnormal C-V curves. The excess Pb content in the films and the accumulation of Pb at the interface were high in PLT films deposited on Pt/Ti/S i, and considerable pinning effect was observed. As LaNiO₃ would absorb most part of the excess Pb in PLT films, the content of excess Pb in the films deposited on LaNiO₃/Si was very low and the pinning effect was hardly observed.